Recent content by Casper98

STX/Mazda bed is the same thing

The whole point of bagging a truck is to ride as low as possible, With a Toyota clip you get very little camber change through the travel of the suspension. If your competent at welding doing a clip swap with gussets or fish plates it'll just as strong as it would be stock. EDIT: Here's a...

Ridiculous amount of Camber is what's wrong with the Ranger's front end! lol

I didn't have to drill the bracket, or flip the pin in the center on mine....

http://www.therangerstation.com/Magazine/Dec%2005/tech.htm

It's the Ranger lean, you can pull the passenger side spring and trim a little to level it out.

No one makes drop spindles for a ranger only drop beams, a arms or springs.

boom!

What do you have against using a yota clip? there are reasons why people use them. They are damn near the same width, same bolt pattern, gets great lift and hardly no camber so you can ride low all the time. If you are thinking about doing a clip swap just SFBD while your at it.

89-94 Toyota clip would be ideal.... http://www.rangerpowersports.com/forum/f413/why-yota-clip-276232.html http://www.rangerpowersports.com/forum/f413/georgia-peach-257743-8.html http://www.rangerpowersports.com/forum/f413/yota-clip-installation-pictures-279185.html

front I've been thinking about getting mine rolled a little my tires are really close to the lip

if its possible can you get pics of the inside of your fenders?

Looks good pulled bed sides?

Nothing new just washed up the truck and took some pics because I haven't posted some in a while. If the weather stays nice this week I'll get some pics other than in front of my house lol