• Welcome Visitor! Please take a few seconds and Register for our forum. Even if you don't want to post, you can still 'Like' and react to posts.

Search results

  1. aeraceranthony

    Class 7/ Class 7s

    I just wanted to get your opinions on the two classes. I am getting another truck due to my last one getting stolen. I am looking to get into off road racing, mainly CORR. Which class do you think will better suit someone getting into the sport? How much am I looking at money wise? Any other...
  2. aeraceranthony

    98 Explorer Springs

    I picked up a 98 rear end(8.8, disk brakes, T Lock, 3.55) for $100 and it came with the leaf springs. I just want to know roughly what the ride hieght will be with these different combos... 95 Ranger springs, Rear end over the springs 95 Ranger springs, Rear end under the springs 95 Ranger...
  3. aeraceranthony

    5.0 Rocker Arms

    Would these fit(I know I also have to change the studs)? 1994, 3.0 http://store.summitracing.com/partdetail.asp?part=PRO%2D66879&autoview=sku
  4. aeraceranthony

    Pulling codes, Opinions?

    KOEO Stored: 327-EGR feedback signal is/was low - EVR or PFE Non-Stored: 327-EGR feedback signal is/was low - EVR or PFE 332-EGR did not open/respond during test or if memory code, did not open intermittantly - EVR or PFE 336-PFE sensor signal is/was was high -PFE 337-EGR feedback signal...
  5. aeraceranthony

    Cost for a V8 swap

    How much are you guys spending on third gen efi 5.0 swaps?
  6. aeraceranthony

    Rough Idle and Pulling 3 Codes

    1994 3.0L Auto 80,000 miles Pulling 3 codes from a check engine light on the ignition only: 157 (MAF sensor circuit below minimum voltage) 335 337 (EVP or DPFE circuit above maximum voltage) Car is running really rough. Idle is about 650RPM. Is the MAF bad? I cleaned it and no such luck. All...
  7. aeraceranthony

    Dyno Day this Saturday at Vaca Performance in Downey, CA

    Do you have Horsepower? Prove it at our monthly Dyno Day and BBQ! Join us the 4th Saturday of every month January 31st (February 28th, March 28th, April 25th) from 9:00 AM to 4:00 PM. For only $45.00 you get two power pulls on our DTS CD-36 Chassis dyno, a graph of your vehicles...
  8. aeraceranthony

    My 1994 Ranger

    Very nice! Might I suggest some wheel spacers/adapters. Flush mount the wheels with the body :headbang:
  9. aeraceranthony

    Rear Brake Question

    http://www.jegs.com/p/Ford+Racing/762880/10002/-1 Will these work on a 94 explorer 8.8?
  10. aeraceranthony

    how to go lower in the back?

    Flip Kit, or Flip the axel over the leafs for about 4 to 5 inches. http://store.summitracing.com/partdetail.asp?autofilter=1&part=DJM%2DFK3001%2D4&N=700+4294924760+4294908331+4294907827+4294925130+4294839061+115&autoview=sku
  11. aeraceranthony

    roll pan

    summitracing.com they should be around $100
  12. aeraceranthony

    Cluster Question

    Will a 94/95 cluster work with a 1990 Mustang 5.0 computer?
  13. aeraceranthony

    Drag Race Setups

    Anyone have any drag race set ups for the Gen 3s in here? Thanks.
  14. aeraceranthony

    What happened to Tom Morana site?

    moranav6racing.com I went there today and it was down.
  15. aeraceranthony

    1994 Ranger 2wd

    Im a bit confused. Im looking for gears for my ranger (3.ol, v6, auto, 2wd) and I found some on jegs.com when I did vehicle search, except the ones that came up say its for a 83-91. I dont get it. Please help, thanks. http://www.jegs.com/i/JEGS/555/60022/10002/-1#

Sponsored Ad


Sponsored Ad

Top