I got my 98 Ranger running and decided to drive it to work for the first time.
It had been running good around town at low speeds and everything but when I got it on the highway it started messing up.
I got up around 60 and it just lost its power. push the gas and nothing until I slowed way down...
Can someone tell me exactly where I hook up the code reader scanner to my 98 Ranger, I have looked under the dash on both sides and in the engine compartment. I am missing it.
Thanks
Actually I pushed my 98 Ranger outside to clean the garage because its not quiet running yet and I rolled the windows up and locked the doors because of the weather, then I realized I dont have a door key ,just ignition key.
Has anyone used a slim jim on their Ranger and how did you do it?
Do I...
Ok guys I have installed my new (not really new, has 50,000 miles on it) 3.0 v-6 into my 98 ranger and have hooke everything back up.
I have yet to start it of course because there are a few things still.
I am missing where something goes, on the injector rail passenger side there is a little...
Hello I just have a quick question.
I am ready to pull out my 3.0 v6 out of my 98 ranger and put in the motor I purchased this weekend, but can I pull it out with the torque converter still attached to the flywheel then unbolt it when its out and then bolt to the new flywheel and replace back in...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.