who makes a good body lift?

[pillen140]

anyone know who makes a good 3 inch body lift for a 95 ranger 4x4 ext cab? i know performance makes one, but i dont know if it comes with the bumper brackets steering shaft ext., shift extension, and what not. does anyone know? i dont want a cheap crap one. i want to know where is the best place to get them too, they are all over the internet but i dont know the best price and honest place. thanks in advance!

 

[mkpecor]

check out james duff .com

 

[pillen140]

duff says 2inch, and for only b2's.

 

[rngrnewbie]

when i put my performance accessories one on my 1997 supercab 4x4 xlt it came with bumper brackets and a steering extension hope that helps i believe yours will be the same.


chris

 

[zapper2003]

I don't remember for sure, its been a few years, but I know for a fact my Perf. Acc. 3" lift (95 ranger) came with the bumper brackets. I THINK it came with the steering extension, and I know for a fact that I had to purchase the shifter extension.

 

[gnardoom]

2 inch is a good body lift, my old truck had 3 inch it looked bad and stretched everything out a bit too much

 

[99stepside]

4 wheel parts

I went shopping for about 3 months before I bought my body lift. The performance accessories body lift kit comes with all hardware other than the manual shifter extension. i went through 4 wheel parts. They were the cheapest by far. Ordered it one day, picked it up the next. No shipping charges, nothing. Summit also has a body lift, which is in fact made by performance accessories. just doesn't come with the bumper brackets, and manual shift extension.

Hope this helps you

 

[pillen140]

cool, thanks for all the help guys.

2 inch is a good body lift, my old truck had 3 inch it looked bad and stretched everything out a bit too much

idk about the 2 inch lift, im getting 33's so i hope that will fill in the gap! thanks though!

 

[pillen140]

actually found it cheapest at 4wheel online.com. $30 cheaper, maybe they will do a price match?

 

[zapper2003]

My truck cleared 33s with no rubbing, but I had installed the 'factory' leveling spacers (its in the library on here) and also the duff prerunner front bumper in place of the factory one, then for good measure I installed fiberglass in front, then in the rear to combat the rusting bedsides.

 

[pillen140]

My truck cleared 33s with no rubbing, but I had installed the 'factory' leveling spacers (its in the library on here) and also the duff prerunner front bumper in place of the factory one, then for good measure I installed fiberglass in front, then in the rear to combat the rusting bedsides.

already leveled, wish i had the money for fiberglass!

 

[zapper2003]

Its nice to get rid of rust, but its always in the back of my mind 'what if'.


What if being deer/accidents off road/ accidents in general. The stuff is gonna just kinda 'blow up' in the event of an impact that hard. I will say though, i had a deer 'side swipe me', its nose left a wet streak from the front of the box to the wheel well and didn't break, but then again she didn't really hit the box as hard as she did the tire/wheel.

 

[pillen140]

true! but the impact would look cooler. jk. that is lucky, just a nose streak!

 

[pillen140]

okay, i bought the performance accs one from 4wheelparts, after they price matched the 4x4online price!!!! and they were cheaper on the gap guards and shifter ext.!!! really nice people! i would buy anything from them now. thanks for the help guys!