What bends do i need to do to exit out infront of the tire?

[Daven]

I am wanting to run my exhaust out infront of the passenger side tire, but was wondering what bends i will neeed since i am pretty sure u need some? Thanks lol

 

[Boggin]

if you dont have a bender you can just cunt the pipe in several places and re weld

 

[Daven]

if you dont have a bender you can just cunt the pipe in several places and re weld

First, I just noticed that i wasnt very specific lol. I want it going out the front of the "rear" passenger tire

And i was wondering what all i need to have for bends in my sxhuast? Can i just run the pipes straight from the cat, to the muffler (or not if i decide), then just a 45 degree angle (maybe a bit more, im not sure) out infront of the rear tire? I remember being told that there needs to be bends for some reason like so the air doesnt push it back in and stop it from exiting? Im not really sure, thats why im asking

 

[RangerFabWorks]

a 45'' and a 90'' pipe should be just fine.



you can always return the ones you dont use.

 

[Daven]

a 45'' and a 90'' pipe should be just fine.



you can always return the ones you dont use.

I dont have any pipes yet, i am thinking of just doing it at home myself incase the shop wont do my exhaust how i want it. Isnt there an added total degree of bends i need to have? Like if i went with the 2 bends like that i would have 135 degree of the bend? lol Idk, i barely know what im talking about anymore...

How about this... how would i map 2.25" exhaust from the cat, to a flowmaster origonal 40, then have the tip going out infront of the rear tire? Thanks

 

[Daven]

And i guess while im weighing my options here... How much of a sound difference would there be between it coming out the side like i said above, or just having a turndown after the muffler? Im going for the deepest and loudest roar i can

 

[ranger]

just look up under your truck and do some measurements. i did my exhaust at home myselft i just measured it up bought the pipe and had it bent at a shop then put it on myself. Here it is http://www.youtube.com/user/deadeye4992?feature=mhum#p/a/u/0/AE5uYuZLxDo

 

[84stealthranger]

if you dont have a bender you can just cunt the pipe in several places and re weld

hahaha ive alomost done that a few times on here