97RangerXLT
Forum Staff Member
TRS Forum Moderator
💻 TRS Socials
Article Contributor
TRS Event Participant
TRS 20th Anniversary
TRS 25th Anniversary
GMRS Radio License
- Joined
- Sep 18, 2007
- Messages
- 7,583
- Points
- 3,101
- City
- Anderson, IN
- State - Country
- IN - USA
- Other
- 2020 Ford Edge Titanium
- Vehicle Year
- 1997
- Vehicle
- Ford Ranger
- Drive
- 4WD
- Engine
- 4.0L
- Transmission
- Automatic
- Total Lift
- 2"
- Tire Size
- 31"
so my Poulan Pro weed wacker has got to the point of non running and me having to yank on the cord a minimum of 20 times to get it to start, if it starts.
the last few years I could get it to start after yanking my arm off, but I would have to run it on choke mode or it would die, and it would rev up to the point of scary... this year I put a new carb on and replaced the fuel lines and plug/ air filter. still have to yank my arm off to start it, but when it starts I have throttle control again but absolutely no top end speed and it slurps fuel now. messed with the carb a little bit, I am over this fawking thing and it is 11 years old and I am ready to pitch it sideways into a lake.
so. Rather than derail the "free tool thread any further since it was discussing chain saws... I created this one. I am currently looking at a Husqvarna straight shaft wacker from Lowes, but it is 199 bucks. and that is on sale for 20 bucks off.. I paid like 75 brand new for the poulan 11 years ago.
I honestly do not want to spend more than 200 on it, but I want it to last and I don't want to spend a half hour messing with it to get it to run crappily and guzzle the fuel I put in it in 20 minutes..
Maybe I need to take a queue from PetroleumJunkie and throw the thing behind the shed and go out and pee on it every few days...
AJ
the last few years I could get it to start after yanking my arm off, but I would have to run it on choke mode or it would die, and it would rev up to the point of scary... this year I put a new carb on and replaced the fuel lines and plug/ air filter. still have to yank my arm off to start it, but when it starts I have throttle control again but absolutely no top end speed and it slurps fuel now. messed with the carb a little bit, I am over this fawking thing and it is 11 years old and I am ready to pitch it sideways into a lake.
so. Rather than derail the "free tool thread any further since it was discussing chain saws... I created this one. I am currently looking at a Husqvarna straight shaft wacker from Lowes, but it is 199 bucks. and that is on sale for 20 bucks off.. I paid like 75 brand new for the poulan 11 years ago.
I honestly do not want to spend more than 200 on it, but I want it to last and I don't want to spend a half hour messing with it to get it to run crappily and guzzle the fuel I put in it in 20 minutes..
Maybe I need to take a queue from PetroleumJunkie and throw the thing behind the shed and go out and pee on it every few days...
AJ

