sas drive shafts??

[quaallen]

i got a buddy going to do sas with d44 full width and 9" rear. but i need to know what drive shafts im gonna need. the truck is a 89 ranger 2.9l 4x4 and for now i will have this engine tranny and trans for now. so what drive shaft would i need or how do i go about finding out what i need. thanx

 

[brendank]

You go about finding out what you need by putting the axles in the truck, and then measuring the length needed. It's pretty straight forward...

 

[quaallen]

sweet . thanx

 

[projectnitemare]

Highly doubted you will find one that will fit from the junkyard. If you have a good chop saw, tools to ensure you have a square cut and a welder you can make a driveshaft. Depending how good you made it you will be able to get it balanced. If you doubt your skills just have a shop make it.

Matt