roll pin for clutch slave cylinder

[bowman24985]

Does anyone know what size the roll pin is in the 1990 ford ranger clutch slave cylinder?

 

[Mark_88]

Hi and welcome to TRS~!

Not sure the specs on that pin but I can guarantee that it is the same size as a nail punch...because that's what I used to remove one. Although a nail punch is tapered so I'd say it is the end of the nail punch...

Sorry, but my usual source for parts and specs (on-line manual found on this site) is wonky and I can't find much in the Haynes after it got soaked in a water tight container...

If you don't get an answer in this section by tonight I'd say post it in the Urgent Help section if it's urgent...or the General Discussions...that's where most members who can help will hang out...

 

[adsm08]

It's a hair bigger than 3/32.