ride height ?s

[rangerboy92]

ok i have a 1992 ford ranger 2wd and would like to do a 2/2 drop (i like the stock rake) i know the springs have saged on all four coners i just dont know how much. i would like to know this before i decied what to buy. so if you know what the ride hight is and where it is messured from or where to get the info please help

 

[doorgunner]

good question about the OEM ride height......I don't have an answer, but it wouldn't do much good to buy 2" drop coil springs if the truck is already sagging an inch or more!

Maybe doing a 3"/3" drop would work if you can't find out what the OEM ride height was.....

My 2 cents.......

 

[ILLEGALCONCEPTS]

agreed, you could figure probably an 1" or so in drop over what you have now. You should decide if you want more or not now. If you do 3" beams up front that'll give you a solid 3". The rear could get a flip kit and lift shackles to bring it up to the height you want.

James

 

[constant_projecttruck]

bag it...then you can ride with the the height at whatever you want....

I'm joking but you're looking at between 3/4" to an inch and a half of sag. When I did my coils on my 92...i got 7/8" of drop. That stat should help you. And I got Belltech 2" i didn't cut because cutters are quitters.

 

[slammedxonair]

If you ever plan on bagging it go with the DJM 3 inch beams and your set for the future.

 

[rangerboy92]

ok thanks for the info on the Belltech drop springs
if i remember correctly about an 1 1/2 is what the specs are on a 2.3 and i don really wont to go lower than a 2/2 drop cause i still need it as a Daily driver and i love hiking and camping (DIRT ROADS ARE FUN !!!!)