Removing the Rear window on my 93 Ranger

[4.6StangRage]

I need to remove the rear window on my 93 Ranger XLT. The Rear window is a slider and I keep finding good slider setups at pick n pull. How do I remove this window. It seem you pry the rubber boot from the window frame but that just seems too good to be true . I don't see it but I would think it would be glued in with sealant. How do you do this?

thanks!

 

[kevinsranger]

its bolts in from inside the cab, remove the plastic from inside around the window and there is a bunch of nuts holding it in, there will be window sealant too but you wont get it out without removing the nuts first

 

[4.6StangRage]

Is it difficult to get to these bolts? On a scale of 1 (easy) to 5 (very difficult) how difficult would this be to remove and Install into my ranger?

 

[kevinsranger]

very easy, just a matter of taking the plastic surrounding the window off and taking the nuts off, they are 8mm or 10mm nuts and there is prob about 15 or something like that.

 

[Fast Fords]

depends if its a super cab or not. I put in a slider an all i had to do to my reg. cab is pull the seal off from the inside and push it out - no bolts, no nothing..although its good to have someone help for this part. If its a super, then there are screws to be removed when you pull up the seal - possibly at the bottom center of the frame; remove them and as well, push. remove and replace with new window and you are done!

 

[4.6StangRage]

depends if its a super cab or not. I put in a slider an all i had to do to my reg. cab is pull the seal off from the inside and push it out - no bolts, no nothing..although its good to have someone help for this part. If its a super, then there are screws to be removed when you pull up the seal - possibly at the bottom center of the frame; remove them and as well, push. remove and replace with new window and you are done!

my bad for not including that it is a Regular cab. So all I do is just pull out the inner seal, push the window outward, install the new one from the inside then replace the seal? No sealants or anything to remove or install?