jeepxj2007
Well-Known Member
I have a 94 ranger with 4.0 al4d and auto tcase, I am about to pick up a BW 1350 manual shift tcase, it came from an 84 ranger, will this work with my truck? and the al4d besides swapping in the linkage?
-
Welcome Visitor! Please take a few seconds and Register
for our forum. Even if you don't want to post, you can still 'Like' and react to posts.
Quick Tcase ?
- Thread starter jeepxj2007
- Start date
doing the same swap soon, youll also need the drive shaft from the donor truck but other then that should be good to go
- Joined
- Feb 28, 2001
- Messages
- 9,592
- City
- Dayton
- State - Country
- OR - USA
- Vehicle Year
- 1990, 1997
- Drive
- 4WD
- Engine
- 2.3 (4 Cylinder)
- Transmission
- Manual
- Total Lift
- 6
- Tire Size
- 35"
the only problem you will run into is the front driveshaft will be too long (unless you have the hybrid front axle), you will have to use the driveshaft from the 1350 because the slip joint is in the case not the shaft like with the electric 1354 you have. you would need to shorten it 1" if lifted or 1.5" if stock height
Sponsored Ad
Sponsored Ad
TRS Events
Member & Vendor Upgrades
For a small yearly donation, you can support this forum and receive a 'Supporting Member' banner, or become a 'Supporting Vendor' and promote your products here. Click the banner to find out how.
Recently Featured
Ranger Adventure Video
TRS Merchandise
Follow TRS On Instagram
