-
Welcome Visitor! Please take a few seconds and Register
for our forum. Even if you don't want to post, you can still 'Like' and react to posts.
Putting in a new heatercore?
- Thread starter 87danger
- Start date
martin
Well-Known Member
- Joined
- Aug 6, 2007
- Messages
- 3,218
- Age
- 78
- City
- St Bruno, Quebec
- Vehicle Year
- 1984
1991
- Transmission
- Manual
about ten minutes. fifteen if you stop for a smoke or a beer.
Mazda
Well-Known Member
- Joined
- Aug 8, 2007
- Messages
- 524
- Age
- 55
- City
- Temecula, CA
- Vehicle Year
- 94
- Engine
- 2.3 (4 Cylinder)
- Transmission
- Manual
Just did it yesterday. Due to me being stupid this pat summer.
1. Undo heater hose clamps. Unhook heater hoses. Have a drain pan on the floor
2. Grab a light and get under the pass side dash you will see where the heater core box is.
3. Undo 4 screws from the core box. Tip and slide the heater core out.
4. Install is the reverse
Bryan
1. Undo heater hose clamps. Unhook heater hoses. Have a drain pan on the floor
2. Grab a light and get under the pass side dash you will see where the heater core box is.
3. Undo 4 screws from the core box. Tip and slide the heater core out.
4. Install is the reverse
Bryan
Sponsored Ad
Sponsored Ad
TRS Events
Member & Vendor Upgrades
For a small yearly donation, you can support this forum and receive a 'Supporting Member' banner, or become a 'Supporting Vendor' and promote your products here. Click the banner to find out how.
Recently Featured
Ranger Adventure Video
TRS Merchandise
Follow TRS On Instagram
