Welcome Visitor! Please take a few seconds and 
- Joined
- Jun 6, 2009
- Messages
- 1,922
- Vehicle Year
- 1993 / 2001
- Transmission
- Manual
Hey guys, regeared my rear a while ago, but didnt have time to do the front, so I tackled that this weekend, heres a couple of pics.
carrier with old bearings off and ring gear removed...you can visually tell the difference between teh 4 56 and 3 73 ring gear eh?
oh and this thing is tits for removing carrier bearings
the case is there empty with new seals, along with teh pinion and a bunch of new bearings:
everything installed temporarily, backlash checked and ran a pattern. I used my dana 35 skid as a holding jig ahaha. (decent drive pattern too eh?!)
while the axle shafts were out i swapped in new SPICER 5-760x u joints.
Oh, and just for comparison, here is a Dana 35 u joint next to a Dana 28 u joint...
peace
carrier with old bearings off and ring gear removed...you can visually tell the difference between teh 4 56 and 3 73 ring gear eh?
oh and this thing is tits for removing carrier bearings
the case is there empty with new seals, along with teh pinion and a bunch of new bearings:
everything installed temporarily, backlash checked and ran a pattern. I used my dana 35 skid as a holding jig ahaha. (decent drive pattern too eh?!)
while the axle shafts were out i swapped in new SPICER 5-760x u joints.
Oh, and just for comparison, here is a Dana 35 u joint next to a Dana 28 u joint...
peace
