Welcome Visitor! Please take a few seconds and 
85_Ranger4x4
Wallows in rivers
TRS Event Staff
TRS Forum Moderator
Article Contributor
V8 Engine Swap
OTOTM Winner
TRS 20th Anniversary
VAGABOND
TRS Event Participant
Out of a '84 Bronco with the fixed rear output.
Changing the rear output shaft bearing. The old one had a shield on one side and was retained into the housing by a snap ring in the housing. My new one (SKF 6207-NRJ) has no shield and has a snap ring around the outer race.
Big deal or no big deal?
Changing the rear output shaft bearing. The old one had a shield on one side and was retained into the housing by a snap ring in the housing. My new one (SKF 6207-NRJ) has no shield and has a snap ring around the outer race.
Big deal or no big deal?
