New clutch problems

[rangeroutlaw]

I have a 98 ranger that I just put in a new clutch, slave & flywheel. I got everything back together & bleed the clutch. I didn't fill the tranny with fluid because I didn't to drain it again if I had to take everything apart. Anyways I raised the rear up then when I started it I went to go put it in 1st when the tires started moving. Any suggestions? Just want to clarify I didn't have it in 1st it was just before I shifted into 1st.

 

[adsm08]

Sounds like it's in gear. Are you sure the shifter is actually in N?

 

[rangeroutlaw]

when it's in neutral the tires dont move. the tires only start moving when I move the stick over to were the 1st gear position is, right at the moment I'm about to put it in 1st

 

[adsm08]

So it's still out in the neutral gate, between 1st and 2nd, clutch to the floor, and the tires start to turn?

 

[rangeroutlaw]

yes, clutch in. tires start to turn right when I line up the stick to put it in 1st & push up. I want to be clear though I'm not actually putting it into 1st but starting to push the stick up like I'm putting it into 1st.

 

[84bluebronco2]

Your clutch isn't disengaging. That's a given seeing as the tires have motion while the pedal is depressed. Did you bench bleed the master?