never been done?!?!?!

[Endoverend47]

so Rob from Stainless Brain Fabrication (www.stainlessbrainfab.com) and i are planning to do something thats normally a "jeep" thing......TUBE FRONT FENDERS!!! anyone interested in a set?

heres some he has built for jeeps, the ranger shouldn't be a problem.
examples of the work SBF does.
the welds (mig)

aluminum

 

[The Mud Addict]

I made a set for a buddies Toyota a few years ago, was able to clear 37's with only a 2in bobylift after I got done

 

[strvger]

think i'll wait for the whole tube body for when the ranger body is too rusty to repair.

 

[86 slo-vo]

ill be doing a set for mine here in a week or two.

 

[chrwilkins30]

make up a set so that we can see what a finished product looks like installed.

 

[jarfly]

I'v been thinking about doin this with an old fender I have. Just don't have the tubeing yet. What I was thinking was cut at the body line and just run tubeing there and make it come down on an angle like they do with the jeeps. It would't have any flares but still look pretty wicked imo.

 

[RollinWOT]

If I do say so myself those look effing awesome. How much for a set?

 

[86 slo-vo]

I'v been thinking about doin this with an old fender I have. Just don't have the tubeing yet. What I was thinking was cut at the body line and just run tubeing there and make it come down on an angle like they do with the jeeps. It would't have any flares but still look pretty wicked imo.

thats what im doing on mine. rears are almost done.

its going to be hard to do a flare and make it look right on a ranger, it works good on jeeps because the front curves in.

i dont want anything sticking out past the body anyways.

 

[Musick17]

I dont know how I fell with the look of those flares on a ranger. MAYBE.. if its only sticking out a little bit it would be alright. But if its as much as those jeeps, then no thanks.