my homemade d-ring bumpers

[rickcdewitt]

here's some shots of the bumpers and winch cradle i made.

and one of the back with bent brackets

 

[Will]

I wish I could wind my winch up that nicely. It looks like a storks nest after an all night orgy.

The insides of your front tires are showing air under them.

 

[rickcdewitt]

the cables do look like that until you use them a few times.looks better than your wreck of a b2 anyway.well you were bright enough to notice there is no motor in the truck,thanks for the compliments

 

[whitetrash96]

It looks pretty good, any pics of the backside of the front bumper. I'm wodering how much of a PITA it is to put your pin thru for the winch mount.

 

[rickcdewitt]

so far only blurry ones. but its not too bad.the pin goes through about 4 inches back from the face of the bumper.plenty of room to get the pin in and out,you just need to feel around a little for the hole.

 

[predator]

dude that is a really nice job!!! how much do you have into the front bumper?

 

[rickcdewitt]

probably 250$ in steel for front,rear,and cradle.i cut out cardboard templates first and duct taped them together to get the look and fit i wanted,then cut out the steel and.it was a fun project,but i'm not done with the rear.it will undergo some major surgery some time in the future.

 

[Forcus]

That's pretty close to what I want to do, and pretty nice looking. I want / need D rings front and rear and would like a receiver so I can buy one winch and remove it when I don't need it (99% of the time).

 

[rickcdewitt]

its not quite what i envisioned ,but close enough for me to be happy with it.

 

[DennisH]

you did a real good job man. Nice i like it