I can cut the Fuel door out if this bed for you if you want it. There is rust in the lower panel is the reason I decided to use this bed for patch panels.
Welcome Visitor! Please take a few seconds and Register
for our forum. Even if you don't want to post, you can still 'Like' and react to posts.
I only ask because I'm looking for somebody who's going to be junking their bed; because I want the fuel door area. I want to graft it onto my bed and resurrect the dual fuel tank option. Since all our bed floors still have the relief for the secondary fuel tank neck in it, all I need to do is put in the fuel door and I would use a fuel cell in the area where the spare tire is.
Yes please move to build thread I thought I started it in build section. Thanks for your assistYa know @Terrys87
This looks more like a build thread then an introduction post. With your permission... I'm going to move it to the correct forum.
Thannks!! I should of investigated it before just swapping it out but now I know I am good for a while in that part.^^^ Classic example of a tired first-generation ignition switch. Good catch!