Welcome Visitor! Please take a few seconds and jkw
Active Member
- Joined
- Jan 9, 2012
- Messages
- 42
- Vehicle Year
- 1997
- Transmission
- Automatic
alright guys I got my frame stripped down and painted for my full width 44 swap from a 78 bronco. I have coil buckets from a 77 f100 to space the coils out to the full width.
my problem is I marked center on the factory buckets and it looks like the 2wd coil buckets are offset 3/4"(i.e. the drivers coil bucket sits 3/4 further towards the rear of the frame than the passenger one). Is this true or did I screw up measuring?
Also where did you guys find was a good place to measure from to make sure the new coils are placed evenly?
thanks in advance
jason
my problem is I marked center on the factory buckets and it looks like the 2wd coil buckets are offset 3/4"(i.e. the drivers coil bucket sits 3/4 further towards the rear of the frame than the passenger one). Is this true or did I screw up measuring?
Also where did you guys find was a good place to measure from to make sure the new coils are placed evenly?
thanks in advance
jason
