Manual hub swap question

[jballard81]

Evening!
Found a set of mile marker manual locking hubs on a 96 ranger at the boneyard this AM.

I didn't have the right tools or effort (it was 35 degrees with sustained 25+MPH winds) to take the hub apart any further to get the spindle nuts. I currently have automatic hubs on my 94 with the dana 35TTB. Is this the correct right conversion kit? https://shop.broncograveyard.com/D35-Hub-Conversion-Kit/productinfo/82001A/

I ask b/c I read the tech thread about it and that says i need:

• 95-27997 – Dana 35 Manual Hub Conversion Kit

which anywhere i look is $84... while the one on bronco graveyard is $30.

Thanks in advance!

 

[SenorNoob]

Unless their listing is very wrong, yes. That's what you want. Do you have the socket? If not their price on it is pretty cheap. Combine shipping and save.
https://shop.broncograveyard.com/D44-Spindle-Nut-Socket-2-1_4/productinfo/296252/

 

[4x4junkie]

×2, that kit looks to be correct.
Also ×2 on the D44 hub socket. It doesn't fit the inner D35 nut, but fits the outer nut much better than the one with the prongs on the end and won't slip off when you try to tighten it down (the inner nut only needs 15 INCH-lbs anyway, which you can get it that tight just with your fingers (or if needed, a flat screwdriver in one of the slots, then lightly bumping the handle on the end with your palm).