• Welcome Visitor! Please take a few seconds and Register for our forum. Even if you don't want to post, you can still 'Like' and react to posts.

MAF sensor?


ckevincawley

New Member
Joined
Jun 26, 2014
Messages
4
I recently replaced the Head and Water pump in my 2003 Ranger with a 2.3L DOHC at 245,000 miles. The only codes that are being thrown after the job is P0108 cleaned the MAF and tried again. It threw it again and P0068. It does idle rough rough, sometimes a little high sometimes a little low and will even stall when no load is on the engine at times. After the head job the only other issues I've had is it seems to go through coolant hose fittings faster than I can buy them. Any help would be great.

Sent from my Z796C using Tapatalk
 
Also I forgot to mention I did unplug the MAF and didn't notice a real change in how the engine was running.

Sent from my Z796C using Tapatalk
 
You have a vacuum leak, that's the common link in those two codes.

Check the EGR system vacuum lines, if your engine has an EGR system.
And any other vacuum hoses.

Sensors rarely fail, not never but rarely, people often waste money on replacing sensors which is like "shooting the messenger", the fact the computer set a code means a sensor's data detected a problem, so sensor is working as it should.

A vacuum gauge costs about $25, and is a handy tool for diagnosing many engine problems, including vacuum leaks.
Gas engine should have about 17" of steady vacuum when idling
Good read here on using a vacuum meter: http://www.gregsengine.com/using-a-vacuum-gauge.html


What is happening with coolant fittings?
Are they rusting out, if so you have some bad grounds, or lots of salt in the cooling system, this causes electrolysis, eats away metal from the inside out.

If they are "popping off" then rad cap is bad or has wrong pressure for the system.
 
Well the coolant lines are consistently going through plastic fittings

Sent from my Z796C using Tapatalk
 
Its been a couple days since I blew my last coolant line. I'm set up to borrow a smoke machine to find the vacuum leak or leaks tomorrow. Thanks for the help thus far.

Sent from my Z796C using Tapatalk
 

Sponsored Ad


Sponsored Ad

TRS Events

Member & Vendor Upgrades

For a small yearly donation, you can support this forum and receive a 'Supporting Member' banner, or become a 'Supporting Vendor' and promote your products here. Click the banner to find out how.

Recently Featured

Want to see your truck here? Share your photos and details in the forum.

Ranger Adventure Video

TRS Merchandise

Follow TRS On Instagram

TRS Sponsors


Sponsored Ad


Sponsored Ad


Amazon Deals

Sponsored Ad

Back
Top