Looking to lift my 01 Ranger 2 to 3 inches suggestions???????

[014x4]

Hi I'm trying to to lift my 01 Ranger 2 to 3 inches I have looked on line and have only found body lifts I wana do a suspension lift I am also going to do a torsion crank soon. Looking for something cheap all help is appreciated

 

[Beef52751]

search the forum, that being said your options are
1.Body lift
2.Torsion bar crank/beltech shackles
3.Expensive bolt on(im not even sure who makes them any more)
4.SAS

 

[Sunk]

I'm pretty sure Superlift is one the companies that makes kits for IFS Ranger; they're around $1500 new so most people do torsion crank and/or body lift.

 

[Beef52751]

i think your right, but i think i remember hearing they quit making them???

 

[6.2]

i think your right, but i think i remember hearing they quit making them???

nah that was RCD that quit making theirs.
superlifts are still being made as far as i know.

 

[Beef52751]

nah that was RCD that quit making theirs.
superlifts are still being made as far as i know.

you are correct, i stand corrected

 

[pontiacfieroguy]

if your only looking for a couple inches crank the tbar up front and I've got some factory b2 lift blocks for the rear and some aluminum 2"blocks you can have for the cost of shipping.

 

[jcsr950]

Check out www.canuckmotorsports.com. I just ordered new torsion keys and a u-bolt/2" block set up. They have been great with customer service, emails and support. They do lots of torsion keys, shackles, blocks, coil springs.

 

[6.2]

^ why didn't you just crank your bars instead of keys... Same effect, but free.