• Welcome Visitor! Please take a few seconds and Register for our forum. Even if you don't want to post, you can still 'Like' and react to posts.

just wondering


1987 DANGER RANGER

Well-Known Member
Joined
Oct 15, 2007
Messages
118
Age
41
City
Great Bend Kansas
Vehicle Year
1987
Transmission
Manual
On my 87 4x4 with 31x11.50 I can hardly keep it on the road. When going down a blk top or dirt road it wonders so bad it sucks to drive. Some times pulls to the left then to the right. It has an aftermarket steering stab but may be bad it does not leack but my be weak is this poss my prob. I have 31's but plan on running 33's once I put in the d35. Is this a tpyical prob with running larger tires on a ranger. ps it has 6" total lift with 4" sus.



Thanks
 
Who knows this truck has been around for away since it started out in my fam. I plan on getting it alinged once I put the d35 in but that will have to wait until the 4.0 gets put in. Plus a little more info. When I go to flip a U turn and turn the wheel to the left all the way to lock it grabbes the wheel and will hold in that postion, and seems to turn alot sharper when turning left. When you turn to the right it doesent he seem to turn near as sharp or grabbed the wheel
 
Have you checked your front axle ujoints lately? Sometimes a bad ujoint will make the frontend wander. Could have a bad balljoint also.
 
Who knows this truck has been around for away since it started out in my fam. I plan on getting it alinged once I put the d35 in but that will have to wait until the 4.0 gets put in. Plus a little more info. When I go to flip a U turn and turn the wheel to the left all the way to lock it grabbes the wheel and will hold in that postion, and seems to turn alot sharper when turning left. When you turn to the right it doesent he seem to turn near as sharp or grabbed the wheel

Sounds like a huge caster problem and steering angles. Does it have a drop pitman arm??
Also, do you have wide rims ?? Huge back spacing ??? All effect steering.
 
Yes it has a drop pitman the rims are 15/10. Not real sure what you guys are talking about when you state stearing angle. I know when you turn the wheel sharp and get out and look the outside wheel angles to where the top of the wheel is further out then the bottom.
 
Yeah, it's possible your drop pitman arm isn't low enough. The steering linkage in most cases should be close to dead-horizontal, but sometimes (actually quite frequently) it's not, and would cause some of the problems you mention (another is excess wear that occurs on the outer tread edge of the passengerside tire only).

A longer drop pitman arm (or a linkage swap) might be what's needed.

Check the toe alignment before you start tearing anything apart though. Really bad toe could cause those issues too (but would show similar uneven wear on BOTH front tires).
 
Last edited:
Sorry for such a slow response but been busy and working nights suck. As far as I can tell the linkage seems square to the wold. I would take a pic but I have no idea on how to put it on hear. It has an aftermarket drop pitman. Plus the truck tracks real bad on paved roads which have wear marks. So can I rule out a bad stearing stab.
 

Sponsored Ad


Sponsored Ad

TRS Events

Member & Vendor Upgrades

For a small yearly donation, you can support this forum and receive a 'Supporting Member' banner, or become a 'Supporting Vendor' and promote your products here. Click the banner to find out how.

Recently Featured

Want to see your truck here? Share your photos and details in the forum.

Ranger Adventure Video

TRS Merchandise

Follow TRS On Instagram

TRS Sponsors


Sponsored Ad


Sponsored Ad


Amazon Deals

Sponsored Ad

Back
Top