I think something fell off...

[Chance]

yea and i got a shorter wheelbase and a 4 liter oh and i may not have as many scratches (jeezus did you drive that thing through a damn pricker bush field or something?!) but i got plenty more dents!

Yes I did lol

And nope... I haven't flopped mine yet

 

[Slim]

Yes, that is my horse barn

No, I don't have horses

That's what's missing - horses. A 4.0L SOHC conversion would help.

 

[bcost882]

hell just go for a 5OH! then haha

 

[Chance]

That's what's missing - horses. A 4.0L SOHC conversion would help.

Nope.

hell just go for a 5OH! then haha

No. Warmer though...

Except with a bit higher compression and running off propane

 

[Robert_1967]

your truck bed fell off.......... I always thought 4 bolts wasn't enough.

 

[NMB2]

why are you putting in such a big rear axle with a small front? have you considered a 9" or something?

 

[Chance]

Because I'll be getting a d60 for the front eventually and I'd prefer not to get two new axles, just one. That and a 9" isn't 8 lug. I considered doing full half ton, but it's just an incredible waste of money.

This way I don't need to get new gears and a locker for the new rear axle and new wheels when I upgrade to a 60.

Sides, it's 3/4 ton... that's the way they made them from the factory for some stupid reason

Only way I'd ever run a 9" is if I was gonna do a 9" front end too.

 

[kris97ranger]

9" front? i must be missing somthing... how would u turn
________
Paxil Lawyers

 

[Chance]

9" front? i must be missing somthing... how would u turn

by swapping on some knuckles off of a d60 or d44 front axle... it's a custom built thing... If I had the money I'd run a 9" front re-tubed to driverside drop and d60 knuckles... mmmmm... good axle right there.

 

[kris97ranger]

ah ok that makes scense then. like front 14bolt they built on xtreme?
________
Electronic Cigarette

 

[Chance]

Ya, except not a ground draggin' pile of crap

Naw I like 14 bolts. But I'd much rather do the 9" than a 14bolt.

 

[kris97ranger]

how you doing the 351? like wiring and tcase. i have a whole f250 being held for me i was gonna do my swap in september but i rolled my truck a few weeks ago so thats been pushed back
________
Roll Blunts

 

[Chance]

No clue man. It aint gonna happen for a while (if it even happens, I kinda want to get rid of it and just get another 3.0), it's just on the engine stand in my barn... I don't even have a trans/xfer case for it. But I'm gonna rebuild it and convert it over to propane only so I won't have to worry about wiring up a bunch of junk (again, if I decide to use it)

 

[bcost882]

sweet......

 

[NMB2]

3 pages of lots of talk and no action.

chop chop!!!