• Welcome Visitor! Please take a few seconds and Register for our forum. Even if you don't want to post, you can still 'Like' and react to posts.

I have touch drive 4wheel drive and the 4x4 light won't go off


After that, and still no change, we'll look at the shift motor. The brushes that slide on the disc that let the module know where it's at get lost. This is because the grease hardness, and non use, such as over summer, worsens this. But when it doesn't know where it's at, it'll go into fail safe mode and not move.
 
4x4 light

I had the same problem w/ my '94. But my 4x didn't work. Ended up beig motor on trans. case. Put new motor on and problem solved.
 
sounds like one of the relays behind the dash are gettin stuck, just smack the dash a few times with ur fist and see what happens, also just make sure its in nuetral when u try to take it out of 4wd
 
my 1999 ranger 4X4 would go in 4X4 tn switched back to 2x the dash lights stayed in 4X4. I cheched the transfer and it was a cup low. then backed up and light went out.
Spider
 

Sponsored Ad


Sponsored Ad

TRS Events

Member & Vendor Upgrades

For a small yearly donation, you can support this forum and receive a 'Supporting Member' banner, or become a 'Supporting Vendor' and promote your products here. Click the banner to find out how.

Recently Featured

Want to see your truck here? Share your photos and details in the forum.

Ranger Adventure Video

TRS Merchandise

Follow TRS On Instagram

TRS Sponsors


Sponsored Ad


Sponsored Ad


Amazon Deals

Sponsored Ad

Back
Top