Height of body mounts

[JamesC]

Does anyone have the height of each body mount for a Gen 1 ranger? (86 to be specific)

I bought some and I think LMC sent me the wrong ones because things aren't lining up as they should.

I need the height of rubber between the frame mount and the body.

Thanks

 

[Mark_88]

The front two are about 2" and the back 4 are about 4"...I was just looking at them yesterday when I straightened out the body and tightened them down properly...

When I put the cab on I didn't tighten them down because I didn't have time to align everything...but now it is aligned and I got a good look at the mounts...these were all new body mounts from Ford at a cost...brace yourself...of $480 for the six of them...

Yes, they saw me coming from a mile away...

 

[JamesC]

My front 2 measure just over 2in the middle 2 measure just over 2 in and the back 2 measure 3in so i must have the wrong ones

 

[Mark_88]

Actually, either my mind is overworked or my eyes are worse than I thought...

I just measured them...the rear (two pads) measure about 3" uncompressed and the middle one is about 2" uncompressed...I couldn't get at the front with the tape just now, but I'm pretty sure it is the same or slightly thinner than the middle, so about 2"...

Edit: Just curious, but where did you get them and how much were they?

 

[JamesC]

I got them from LMC in the states they are the poly urethane ones and I think they were about 60 dollars

 

[Mark_88]

Wow...sounds like they are the right ones, and I would have flipped for that price...

But, then again, I had to buy the bushings and stoppers as well because my aim with a torch lying on my side was not the best...and because mine were so rusted I thought the nut was part of the washer...

 

[JamesC]

Ya I forgot to mention they did not come with the metal selves so I still have to figure that part out...