Gauge Pod

[Broosedamoose]

Is there a decent gauge pod that will fit the Ranger pillar once the handle is removed? I've tried two different ones and they did not fit right.

 

[Roert42]

https://www.summitracing.com/parts/atm-15308

I got this part number from somewhere on this forum. I never ended up ordering one so I can't confirm.

 

[Uncle Gump]

GlowShift Universal Black Dual Pillar Gauge Pod - Fits Any Make/Model - ABS Plastic - Mounts (2) 2-1/16" (52mm) Gauges to Vehicle's A-Pillar https://www.amazon.com/dp/B001PBJECI?tag=959media-20

 

[Broosedamoose]

View attachment 95958

GlowShift Universal Black Dual Pillar Gauge Pod - Fits Any Make/Model - ABS Plastic - Mounts (2) 2-1/16" (52mm) Gauges to Vehicle's A-Pillar https://www.amazon.com/dp/B001PBJECI?tag=959media-20

Awesome! Thank you! I’m going to be installing the M90 supercharger so obviously I need a boost gauge but what should I put in the second hole?

 

[Roert42]

Awesome! Thank you! I’m going to be installing the M90 supercharger so obviously I need a boost gauge but what should I put in the second hole?

Could setup an an exhaust gas temp gauge or gauge for a wideband O2 sensor.

Would be pretty useful if you plan on trying to tune the thing yourself or trying to setup a water meth injection

 

[Uncle Gump]

They make a single pod that replaces the upper column shroud. I believe @G8orFord put one in his truck. He said it was for a f150.

 

[G8orFord]

They make a single pod that replaces the upper column shroud. I believe @G8orFord put one in his truck. He said it was for a f150.

Yes I did and it was for an F-150, IIRC.

 

[Broosedamoose]

The double looks good! So you ordered one for an F150 and it fits that nice? Does it just clip on or do you have to screw it in place? I think I’m going to go with boost and A/F ratio for gauges. I’d like to paint it to match the interior color to.

 

[G8orFord]

Just sits over top of existing. Held in place with plastic rivets, IIRC. I'll try to take a look and confirm.