gauge faces?

[LeftRightSplit14]

has anyone installed these or something similar in their truck?

http://cgi.ebay.com/ebaymotors/95-0...013QQitemZ230276496289QQrdZ1QQsspagenameZWDVW

if so, how difficult was it and do you recommend them?

 

[UrbanRedneckKid]

I have them in my '94(diff dash), they weren't that hard to put in. About an hour in a '94

Few Tips,
-Remove the old faces. keeps the needles from rubbing and being "sticky"
-Take note of where the needles sit KOER up to temp
-Reinstall needles KOER up to temp
-Install Blue LEDs or bulb covers in all illumination bulbs and high beam indicator
-Tap into the blue wire from the switch so they dim(yours poss another color)
- Run wires so that they aren't bent were the attach to the faces. Drill small holes if needed.
-As with all electrical get a good ground

Buy them, They change the look of your intierior so much. And if you get a a-pillar pod the look great with Autometer Phantom series. Also if availible get one for the HVAC panel too.