Full mustang swap

[Sn95Ranger]

same train of thought here not really wanting to cut into the firewall.. thanks

 

[bobbywalter]

no reason to cut firewall.

 

[scotts90ranger]

On my '90 I've modified 2 fan housings and need to do it again since I have another hole from the turbo outlet housing... I really need to install the aftermarket one... What I've done is just cut out some plastic and plastic weld it back together and try to put some of the sticky fiberglass heat shield on it which eventually falls off and the plastic melts... I have ideas but never get to them

 

[bobbywalter]

On my '90 I've modified 2 fan housings and need to do it again since I have another hole from the turbo outlet housing... I really need to install the aftermarket one... What I've done is just cut out some plastic and plastic weld it back together and try to put some of the sticky fiberglass heat shield on it which eventually falls off and the plastic melts... I have ideas but never get to them

just use metal and seam sealer

 

[scotts90ranger]

I have better ideas now than I had then, just need to make an aluminum heat shield a little bit away from the plastic... low on the priority list, the rear axle gears wearing themselves out is much higher