front sits low after 4 inch lift

[ajune93]

Hey all,
Just a couple months ago I completed at inch lift to my ranger. Overall everything went well but I did notice the front still sits lower than the rear. I have considered a body lift but that will probably just make it more noticeable. My question is could fix this issues by adding coil spacers to my current set up? Essentially I would be leveling it plus my current lift. Has anyone tried this and would it work?

 

[4.0B2]

should work...

 

[MastuhWaffles]

Just measure the amount you need to match the front with the back, and find a spacer close enough to that measurement. If only you had torsion bars, you could level it easy.

 

[Dune Runner]

Yep use big washers under the springs.

 

[ajune93]

Ok sounds good thanks guys. I'm probably gonna go with actual aluminum spacers. Should need about 2 inches

 

[ajune93]

Thanks guys. I'm going to give it a shot with 2 inch aluminium spacers