Fabtech 3in Spindles...

[anchorshot]

Will they clear 33's on my Edge?

 

[RunBaja]

It will be close. Here is a picture of my truck with Fabtech 3'' spindles with 31's

[/IMG]

 

[anchorshot]

Do you have a rear lift?

 

[Snowboarder7710]

they will if you crank your torsion bars up a couple inches. im running 32s on mine and have plenty of room for 33s

 

[RunBaja]

Do you have a rear lift?

No Lift in the rear, it's kinda the sytle in california. I might end up putting a 1'' block in the rear.

 

[papasnachez]

33s on my edge no problem. I had them on there stock as well with a t-crank and some trimming.

No rubbing. 15x10 rims 3.5" BS by the way.

 

[Tommy]

It will be close. Here is a picture of my truck with Fabtech 3'' spindles with 31's

You have an XLT, he has an edge, an edge can easily clear 33s with a spindle lift, some people have even ran 35" tires with just a spindle lift and t-bar crank. It all depends on how much gap you want in that tire wheel (for flexing, etc.).

they will if you crank your torsion bars up a couple inches. im running 32s on mine and have plenty of room for 33s

Have any pics?

 

[papasnachez]

they will if you crank your torsion bars up a couple inches. im running 32s on mine and have plenty of room for 33s

Yeah, I had the same 33s as pictured above on stock with a t-crank. Trimmed the spots you see in the pics but with the right backspacing that may not be necessary. Mine are pushed out wide.

I went to lift spindles because the ride was rough on the road. Felt good offroad, but couldn't live with it on road.

 

[Tommy]

I went to lift spindles because the ride was rough on the road. Felt good offroad, but couldn't live with it on road.

You're talking about the ride with the t-bar crank yes?

 

[Snowboarder7710]

You have an XLT, he has an edge, an edge can easily clear 33s with a spindle lift, some people have even ran 35" tires with just a spindle lift and t-bar crank. It all depends on how much gap you want in that tire wheel (for flexing, etc.).



Have any pics?

yup here's one..

 

[papasnachez]

You're talking about the ride with the t-bar crank yes?

Yes, the rough ride was from the t-bar crank.

Ride is good now with the lift spindles, as I was able to back off the t-bars some.