danger88ranger
Well-Known Member
I'd say yank out the old buzzbox and start laying down some beads.
-
Welcome Visitor! Please take a few seconds and Register
for our forum. Even if you don't want to post, you can still 'Like' and react to posts.
Extending a wheelbase...
- Thread starter Will
- Start date
I merged this stuff from another thread that was turning into this one. DaveR gave me lots of good info which is now on page one.
I will get a channel bent up as suggested except have it the same size instead of fittig over it. Then put a doubler on the bottom and outside, then weld diamond shaped reinforcements inside the channel at the butts. I may just cut two patches in the floor. I have a stick welder and I doubt I could weld in that gap.
I will get a channel bent up as suggested except have it the same size instead of fittig over it. Then put a doubler on the bottom and outside, then weld diamond shaped reinforcements inside the channel at the butts. I may just cut two patches in the floor. I have a stick welder and I doubt I could weld in that gap.
Sponsored Ad
Sponsored Ad
TRS Events
Member & Vendor Upgrades
For a small yearly donation, you can support this forum and receive a 'Supporting Member' banner, or become a 'Supporting Vendor' and promote your products here. Click the banner to find out how.
Recently Featured
Ranger Adventure Video
TRS Merchandise
Follow TRS On Instagram
