evtm help

[thisfords4u]

anybody have the evtms for 90 ranger and a 94 explorer, spacifically the plugs going to the fuel pump.. Ive got a 8 pin blk and a 4 pin blk on the trk and a 8 pin blu and 4 pin blk from the ex. and they arent matiching up.. HELP please

 

[adsm08]

I don't seem to have access to either ATM, but Ford is pretty consistent with their wire coloring. They do change wire positions around a bit. You need to get the hardshells that fit your pump and then get the wires in the positions that match the donor-vehicle harness.

 

[thisfords4u]

I pulled the fuel pump/sender assembly to find them both bad ( 10 yr old gas does wonders ) and verified wire colors. sender has a orange wire is that grnd?

 

[Mac]

I did look at my '89' Ranger diagrams and at the tank unit, it has black/pink from inertia switch, yellow/white from gage, a black and a orange ground wires. Only time I remember a ground not being black.
Dave of the Nord

 

[thisfords4u]

yep thats the exact colors I have on the sender assembly. Now to figure out the rest. Also when I tried to turn it over the little red wire from the fender solenoid to the solenoid on the starter melted the insulation. This tells me a short in one or the other solenoids. And it did not turn the engine over. I pulled the starter and bench tested it and it worked properly. Meaning it spun and the drive engaged. but with no load against it.

 

[thisfords4u]

Gave in and ordered the manuals off ebay today. about $32.00 total for both