Engine and trans

[Rinny650]

I currently have an AOD in my truck and its making me mad and I dont think it will stand up to the way I drive. Anyway I found a C6 and a NP205 and the guy has the flywheel to the rear output shaft. Its for a 351W. Will the flywheel and bellhousing and everything bolt up to my 302 block? I need to know ASAP. I tried searching but couldnt figure out what to search for

 

[spock1996]

I-6 300, V-6 3.8l rear drive, 302 5.0l, 351 5.8l all have the same bolt pattern.
you will want to use a flex plate for what ever engine you use cause the 351 i think is banced the same as older 302 but differnt than 80or so newer 5.0

 

[alaskan155]

the 351w is 28oz balance, the 302 is either 28oz(60/70s) or 50oz(80's +)

 

[Rinny650]

Mine I believe is an 86 or so. Would a '77 C6 bolt up with the proper flywheel?

 

[spock1996]

if it came off of a 351w it will bolt up to a 302, your 302 flywheel may work, you'll have to check if the converter bolt pattern lines up with your flex plate

 

[baddad457]

Mine I believe is an 86 or so. Would a '77 C6 bolt up with the proper flywheel?

86 302, you'll need a 164 tooth 50 oz/in flexplate, the one from your AOD should fit a C6 torque converter.

 

[Rinny650]

Please tell me they have the number of teeth written on it. If I have to count every tooth ima feel like a one legged man at an ass kickin contest

 

[baddad457]

AOD's only used one size flexplate-------164 tooth.

 

[Rinny650]

So What will I need from the guy that I dont already have on my motor?

 

[baddad457]

Don't know what else but your flexplate should fit.

 

[simonsays]

i would get the flexplate torque converter and trans with driveshaft tailshaft just to be sure..