need to replace the electrical connector for the egr pressure feedback sensor on a 2000 ranger 2.5 engine. old connector fell apart and the three wires are no longer in sequence. new connector has three white wires with no instructions. need to know which original color coded wire goes to which terminal on the new connector. thanx
2.5L ('98-'01) egr pressure feedback sensor wiring
- Thread starter lynnted
- Start date
- Joined
- May 28, 2018
- Messages
- 19,297
- Points
- 601
- City
- 41N 75W
- Vehicle Year
- 2009
- Engine
- 2.3 (4 Cylinder)
- Transmission
- Automatic
- Total Lift
- It's up there.
- Total Drop
- It's down there.
- Tire Size
- Round.
- My credo
- I poop in the furnace.
I have the wire colors but not in any order
1999, 2.5L used brown/white, brown/green and grey/red
Brown/white is the 5volts
Brown/green is the signal
Grey/red is the "ground"
I did see test article that said
top is signal
center is ground
bottom is 5v
so
brown/green
grey/red
brown/white
Its called the DPFE sensor if you want to see if you can find pictures of it with wires attached
1999, 2.5L used brown/white, brown/green and grey/red
Brown/white is the 5volts
Brown/green is the signal
Grey/red is the "ground"
I did see test article that said
top is signal
center is ground
bottom is 5v
so
brown/green
grey/red
brown/white
Its called the DPFE sensor if you want to see if you can find pictures of it with wires attached
Last edited:
- Joined
- Sep 25, 2020
- Messages
- 881
- Points
- 601
- City
- Earth
- Vehicle Year
- 2001 Ford
- Transmission
- Automatic
Not sure if this is the correct version DPFE Sensor, showing HarnessConnector & WireColors?
Sponsored Ad
TRS Events & Gatherings
Featured Rangers
TRS Latest Video
Official TRS Merchandise
Follow TRS On Instagram
