Welcome Visitor! Please take a few seconds and 
- Joined
- Dec 6, 2009
- Messages
- 6,044
- Points
- 3,101
- City
- maplevalley WA
- Vehicle Year
- 1983
- Transmission
- Automatic
Carb spacer felpro #60529 with a new carb gasket, lightly surface the base of the carb put the spacer, gasket nad carb on then slowly just snug it down do not overtighten it. Probably the most common mistake is reusing the old gasket and getting the carb too tight it bends the ears and will never seal correctly. After a few complete warm ups when the engine is cold snug it down again.
