dual piston calipers...

[adsm08]

Ok, so I know this is possible, but I just need the parts list.


I have a 94 D-35, but I want dual piston calipers for it. What parts do I need to make that happen?

 

[RangerSVT]

You will need spindles out
SVT

 

[adsm08]

Oh good. I already need spindles out. I have the steering knuckles inward, but that's it.

 

[RangerSVT]

I don't think I was clear enough, my fault...The 89-94 knuckles have the slide pins that hold the brake caliper on, 95+ calipers bolt on...You will need the spindles (knuckles), rotors, and calipers...I'm not sure if the spindles (where the rotor/bearings sits on) is the same or not...If you undo the ball joints and remove the 95+ unit as an assembly, thats what you need...the ball joints and beams are the same from 89-97, but the knuckles out are different 89-94 and 95-97...Hope this helps
SVT