Dmgctrl88
Well-Known Member
I have an 86 Ranger, losing a 2.9 & A4LD, getting a 302 & C4. It is 4x4 and I am using the original BW1350 transfer case. I have the following drive shafts at my command:
The bottom one is my original. The top one is from a 2003 exploder that is about the right length that I need at 47.5"
These are the lengths that I need for the rear and front driveshafts. The transfer case was moved forward approx 5".
This is my differential and the back of my transfer case.
How do I convert the exploder drive shaft to fit?
The bottom one is my original. The top one is from a 2003 exploder that is about the right length that I need at 47.5"


These are the lengths that I need for the rear and front driveshafts. The transfer case was moved forward approx 5".


This is my differential and the back of my transfer case.


How do I convert the exploder drive shaft to fit?