RangerFabWorks
The O.G blackwidow67
TRS Forum Moderator
Supporting Member
V8 Engine Swap
TRS 20th Anniversary
- Joined
- Jan 31, 2009
- Messages
- 5,291
- Age
- 33
- Vehicle Year
- 1990
- Transmission
- Manual
-
Welcome Visitor! Please take a few seconds and Register
for our forum. Even if you don't want to post, you can still 'Like' and react to posts.
drive shaft for 5 spd from donor mustang.what to use?
- Thread starter svtcards
- Start date
- Joined
- Sep 4, 2017
- Messages
- 912
- Age
- 47
- City
- Lyman
- State - Country
- ME - USA
- Other
- 1987 Ford bronco ii 2wd
- Vehicle Year
- 1987
- Vehicle
- Ford Ranger
- Drive
- 2WD
- Transmission
- Manual
- Total Drop
- 3'' front 4''back
- Tire Size
- 245 35 18
Huh! Not sure what's the deal with mine.also u didn't have to cut that huge hole closer to your dash for clearance of floor for your trans did u?I didn't have to do any of that.from top of shifter mount to bottom of floor on driverside I have about an inch gap and passenger side I have about quarter inch.it seems to be sitting pretty flat and even in the engine bay.not sure y it's like that.any ideas?
- Joined
- Sep 4, 2017
- Messages
- 912
- Age
- 47
- City
- Lyman
- State - Country
- ME - USA
- Other
- 1987 Ford bronco ii 2wd
- Vehicle Year
- 1987
- Vehicle
- Ford Ranger
- Drive
- 2WD
- Transmission
- Manual
- Total Drop
- 3'' front 4''back
- Tire Size
- 245 35 18
Also does your engine seem to have a rack from front to back?it seems mine sits lower in the back then the front.is that also normal?
Sponsored Ad
Sponsored Ad
TRS Events
Member & Vendor Upgrades
For a small yearly donation, you can support this forum and receive a 'Supporting Member' banner, or become a 'Supporting Vendor' and promote your products here. Click the banner to find out how.
Latest posts
-
-
-
-
-
-
-
-
-
Wanted first gen std cab center seat belts for bucket- Latest: 1991 Blue danger ranger
Recently Featured
Ranger Adventure Video
TRS Merchandise
Follow TRS On Instagram
