Planning on swapping in an Explorer 8.8 and doing the 44 knuckle swap. I've located a Dana 44 TTB at a junkyard and was wondering how much of it do I need for the swap? From the spindle out or more? Want to make sure I get everything, would just buy the whole beam but no blace to keep extra stuff like that right now.
-
Welcome Visitor! Please take a few seconds and Register
for our forum. Even if you don't want to post, you can still 'Like' and react to posts.
Dana 44TTB Knuckle Swap Parts
- Thread starter explorerhavok
- Start date
CopyKat
Well-Known Member
- Joined
- Aug 18, 2007
- Messages
- 2,274
- Vehicle Year
- 1987
- Transmission
- Manual
Everything with the knuckles out, including the axle stub shaft. Also try to grab the alignment cams on the top ball joint.
Similar threads
Sponsored Ad
Sponsored Ad
TRS Events
Member & Vendor Upgrades
For a small yearly donation, you can support this forum and receive a 'Supporting Member' banner, or become a 'Supporting Vendor' and promote your products here. Click the banner to find out how.
Recently Featured
Ranger Adventure Video
TRS Merchandise
Follow TRS On Instagram
