Welcome Visitor! Please take a few seconds and 92 5 oh
Well-Known Member
- Joined
- Sep 14, 2007
- Messages
- 123
- Age
- 43
- City
- Virginia Beach
- Vehicle Year
- 1992
1998
- Transmission
- Automatic
My local jy was having a sale so I went to yank out some new gears for my 98 ranger D35 SLA. Ideally I would have taken the entire front axle but the only one with 4.10’s was from an explorer with a vacuum disconnect. I yanked the whole axle and put it in the back of the truck so I can hopefully go back tomorrow and get the gears. I could figure out how the intermediate axle shafts come out. It didn’t look like there were c clips like on the rear. If that’s the case, then do I even have to take out the king pin? And if I do have to take out the king pin, it looks like there’s a roll pin holding it in place. Does it matter which way roll pin comes out? Finally, how does the intermediate axle come out? I searched the forums for exploded diagram or rebuild info but I’m not finding anything with the vacuum disconnect. Any help would be appreciated.
Sent from my iPhone using Tapatalk
Sent from my iPhone using Tapatalk
