clutch

[stocker]

ok the other day my clutch went soft and i checked the fulid level it was almost empty so i added some and then tryed bleeding it but it wont bleed what do u guy think happened i think i might of blown the pressure plate

 

[MAKG]

How do you "blow" a pressure plate?

If you lost fluid, it went somewhere. Probably out the slave, but inspect for other leaks.

 

[dangeranger01]

How do you "blow" a pressure plate?

If you lost fluid, it went somewhere. Probably out the slave, but inspect for other leaks.

+1, it probly is the slave. Check for leaks.

 

[jmkjr72]

your slave cyl is bad i would replace both the cyl and the lines that go to it

 

[stocker]

How do you "blow" a pressure plate?

If you lost fluid, it went somewhere. Probably out the slave, but inspect for other leaks.

lol bein stuiped i did a power brake bout 30 foot and then the clutch went soft

 

[stocker]

well i think it was a seal not the plate but how hard a is a slave cylinder 2 put in

 

[4x4RangerGuy]

You have to pull the transmission since the slave is internally mounted. Plan a lot of time.

 

[MAKG]

your slave cyl is bad i would replace both the cyl and the lines that go to it

It's not necessary (and rather expensive) to replace the line. Only do so if it is damaged or leaking.

It's only available from the dealer and comes with a master cylinder attached.