Clutch setup

[cp]

I'm going to be using a NP435 with my swap and was wanting to keep the original hydrolic clutch on my BII. in the tech section it says that the bellhousing off an 84-84 F150 has a mount for the slave cylinder, will my current slave cylinder bolt up to that or will i have to get one from the F150? if thats the case, do you guys think i'll have any problems hooking that to the stock master cylinder?

 

[mikepotts]

you must use the f-150 slave. i used the same parts in mine, i removed the master cyl, hose and slave from the vehicles, (used the f-150 hose as well) i pulled the retainer pin from the stock master inserted the f-150 hose, and bench bled the system, then installed it in the bronco as a complete unit.

 

[redlinezl]

help me out im having same issue, i wana run a cable on my 2wd ranger 302 with t5