Clutch master cylinder 89 ford ranger

[Atomik]

I'm replacing the clutch master cylinder and having trouble removing the small roll pin that connects the hydraulic line to the master cylinder. It broke and is stuck in there. Any ideas on how to remove it and to put a new one in?

 

[Softwireman78]

Gonna have to find something the same diameter or slightly smaller and carefully peck it out. Alternatively you might be able to offset a jaw on a pair of slip jointed pliers or channel locks and squeeze it out. I've got a cheap pair of slip joint pliers I used a slitting wheel in a grinder to cut a groove in for using on my bait casting reels when flushing stock bearings for removing the pin that holds the spool shaft in place and rides the a x type gear for the cranking handle gear assembly. Hope this helps.

I'm replacing the clutch master cylinder and having trouble removing the small roll pin that connects the hydraulic line to the master cylinder. It broke and is stuck in there. Any ideas on how to remove it and to put a new one in?