Changed tranny now truck runns funny

[1994Rangerxlt]

i pullled my tranny to replace a imput shaft seal. now i put it all back to gether and then went for a drive. NO low end power. truck feels like something holding me back engine feels stressed. then it just picks up and runs fine. not at any certian rpm range. and on engine breakin it back fires and throws flames... i was thinking if it wasnt getting fuel it wouldnt have enought fuel to throw a flame. so my guess is something to do with spark.. what should i try... O2 sensors,icm,ecu,coil pack. i need it to run good by tommorow have a road trip ahead of me

 

[kevinsranger]

maybe you knocked around an o2 sensor pulling the trans? i know its tight around them

 

[1994Rangerxlt]

thats whats i am hoping. i will find out after school.

sorry about the stupid posts i left my computer unattented and stupids high school hoes thought it would be funny to type shit. so i deleted it lol

 

[kevinsranger]

thats whats i am hoping. i will find out after school.

sorry about the stupid posts i left my computer unattented and stupids high school hoes thought it would be funny to type shit. so i deleted it lol

haha i thought you were out of your mind talking to yourself lol.


check them o2 sensors, its very easy to damage one with the trans

 

[1994Rangerxlt]

no i walked away then come back and i was like wtf.


i wont hope to know till after school. its going to bug me till i get to go to the parking lot. ima go to the office and tell them i left my lights on. and walk out and take a look lol

 

[kevinsranger]

no i walked away then come back and i was like wtf.


i wont hope to know till after school. its going to bug me till i get to go to the parking lot. ima go to the office and tell them i left my lights on. and walk out and take a look lol

haha well look at the metal part of the sensor, AND the wires, in case you caught a wire with an ear of the trans on the way out

 

[1994Rangerxlt]

i hope it is something that easy but i never have the best of luck. could a O2 sensor really make the truck run that badly

 

[1994Rangerxlt]

problem solved it was a o2 sensor

 

[1994Rangerxlt]

ok so mayb i lied. i changed my o2 sensors ran fine for 2 or 3 miles then started acting up again.. but ive found if i unplug the passanger o2 sensor it runs better. but engine light coems. on. im really confused now. if i changed both o2 sensors why is it still acting uP?????

 

[bullfisher]

try plugging o2 sensors into each others plugs. you may have crossed them. worked once for me