larsen101
Well-Known Member
i need some help finding some super strong wheel studs i broke some while driving my ranger. any recomendations on buying some super strong ones.
-
Welcome Visitor! Please take a few seconds and Register
for our forum. Even if you don't want to post, you can still 'Like' and react to posts.
broken wheel studs
- Thread starter larsen101
- Start date
canyoncritter
Well-Known Member
usually the studs will break from getting to happy with the rattle gun, Ie to tight. Unless your truck is close to dave@threts truck.then I could see worring about the 1/2 factory studs.
IF you really want some better studs, and willing to drill out your rotors, drums and rear axle flanges, you could install 9/16 or 14mm ARP stud.
but its proably going to run you about 150-200 to get the bit, studs and lug nuts.
so what were you doing that your broke studs anyhow?
IF you really want some better studs, and willing to drill out your rotors, drums and rear axle flanges, you could install 9/16 or 14mm ARP stud.
but its proably going to run you about 150-200 to get the bit, studs and lug nuts.
so what were you doing that your broke studs anyhow?
larsen101
Well-Known Member
wheel spacers and bigger tires= bad combo for stock wheel studs. im going into 4 wheel parts tomorrow to see if they have anything that would help
Sponsored Ad
Sponsored Ad
TRS Events
Member & Vendor Upgrades
For a small yearly donation, you can support this forum and receive a 'Supporting Member' banner, or become a 'Supporting Vendor' and promote your products here. Click the banner to find out how.
Recently Featured
Ranger Adventure Video
TRS Merchandise
Follow TRS On Instagram
