Brake fade
- Thread starter helpme
- Start date
- Joined
- Apr 13, 2009
- Messages
- 15,714
- Points
- 3,101
- Vehicle Year
- '06, '11
- Engine
- 3.0 V6
- Transmission
- Automatic
Need a hellava lot more info to have any meaningful diagnosis.
Last edited:
- Joined
- Dec 1, 2024
- Messages
- 169
- Points
- 101
- City
- Mexico
- State - Country
- N/A
- Vehicle Year
- 1990
- Vehicle
- Ford Bronco II
- Drive
- 4WD
- Transmission
- Manual
- Tire Size
- 235/75R15
Yes, more info please.
Everything should work perfectly fine with Dot 3, but have received recommendations to replace system w/Dot 4 (due to higher boiling point - 446F vs 400F).
Everything should work perfectly fine with Dot 3, but have received recommendations to replace system w/Dot 4 (due to higher boiling point - 446F vs 400F).
Changed the brake booster due to hissing but seems like I had better braking with the old one. Also noticed some non-linear braking. Has anybody had any trouble with those reman boosters? It's a Cardone from Advance. Saw a thread on Reddit about bad Cardone re-man boosters.
Last edited:
did you adjust the rod between the booster & master cylinder?
is the vacuum ok?
is the vacuum ok?
I got the tool and the rod turned out to be 3/16 inches too far out! There was NO instructions with the new booster on setting it up. I had never done a booster before. (Can you tell?) Brakes pretty good now but pedal is still a little low. I'll put some new pads on it this weekend. I know they're low. Thanks all!
WOW! Still working on my brakes. Was driving down the road and the brakes felt fine and firm. THEN, all of a sudden they went soggy! System has been bled, new booster and master cylinder. I think its the hoses going into the calipers. Don't see any leaks and not losing fluid.
lil_Blue_Ford
Cut & Weld
TRS Forum Moderator
⭐Supporting Member
TRS Event Participant
TRS 20th Anniversary
TRS 25th Anniversary
V8 Engine Swap
- Joined
- Aug 6, 2007
- Messages
- 12,184
- Points
- 3,101
- City
- Butler
- State - Country
- PA - USA
- Vehicle Year
- 2000
- Vehicle
- Ford Ranger
- Engine
- 5.0
- Transmission
- Automatic
- Total Drop
- 4”
Yeah, a lot of people don’t think about the hoses if they’re not cracked or leaking (and I’m guilty of this too at times but I’m trying to be better about it). Truth is, the hoses can fail internally and often do. I’ve been kicking around the idea to try and move to stainless braided lines but that requires figuring out exactly what you need because they are more “universal” fit and I just haven’t had spare time to figure it out yet
fluid level? leaks ?
give the rears a good look, including the line going from the axle to the frame.
loose rears cause the pedal to be low.
give the rears a good look, including the line going from the axle to the frame.
loose rears cause the pedal to be low.
Sponsored Ad
TRS Events & Gatherings
Featured Rangers
TRS Latest Video
Official TRS Merchandise
Follow TRS On Instagram
