Welcome Visitor! Please take a few seconds and yeehaw
New Member
- Joined
- Oct 3, 2008
- Messages
- 1
- Vehicle Year
- 00
- Transmission
- Automatic
Hi, I just stumbled upon this site, and must say, wow, alot of good reading and info on here. However, I haven't seen any torque specs...or maybe I'm just looking in the wrong place.
Anyways, I was wondering what the torque specs are on the bolts from the converter to the flywheel are suposed to be? At a guess, we torqued em to 50 ft. lbs. was that too much or not enough? Also, what about the bolts from the bell housing to the engine block?
This was on a 2000 ranger 4wd with 4.0L Ohv engine and auto tranny (5R55E I think) can look tomorrow for the code if needed.
thank ya
Anyways, I was wondering what the torque specs are on the bolts from the converter to the flywheel are suposed to be? At a guess, we torqued em to 50 ft. lbs. was that too much or not enough? Also, what about the bolts from the bell housing to the engine block?
This was on a 2000 ranger 4wd with 4.0L Ohv engine and auto tranny (5R55E I think) can look tomorrow for the code if needed.
thank ya
