• Welcome Visitor! Please take a few seconds and Register for our forum. Even if you don't want to post, you can still 'Like' and react to posts.

bench bleeding clutch master cylinder


ForOffRoadDriving

Well-Known Member
Joined
Aug 10, 2007
Messages
2,715
City
HIGHLAND, MICHIGAN
Vehicle Year
1994
Transmission
Manual
is there a way to bench bleed the clutch master cylinder like you can with a brake master cylinder or am i better off to wait until i have the trans back in the truck to fill it up and bleed it? it seems like if i fill the resevoir and push in the clutch push rod while its in the vise then its just going to get hard since no fluid can escape out of that quick disconnect end. oh yeah, its on a 1994 3.0l ranger with a m5od-r1.
 
do you have the line from the master to the slave out of the truck too? from what i read you need someone to push open the quick connect while you push the piston/rod so fluid can escape.
 
I have a chunk of steel tube that after I cut three sides off it
that I cut a hole in and drilled two holes so I could mount a slave to it while the chunk of steel was clamped in my bench vise.

Above my vise is a shelf and I usually hold the reservoir up with a bungee or a piece of string or wire whatever is handy.

the master is mounted nose up.

and I use a piece of angle stick as a lever to push the rod UP
AFTER I have blocked the port in the dry break open.

I do that with a female half that I couple to it and IT has
a length of clear vinyl tube that runs up and into the reservoir

Just pump the lever until the bubbles stop.

Oh, btw, the "Barp spring" has been removed from the female coupler
so you have to hold them together with your free hand.

The same effect can be accomplished with two people, without
any of the other stuff, but unless you like taking brake fluid showers....

FWIW I keep a spare master, line and reservoir hanging from a hook
on the wall of my garage, it's prebled and I can install it in 15min if
the need arises... I've got another just like it in my "roadtrip spares" box

AD
 

Sponsored Ad


Sponsored Ad

TRS Events

Member & Vendor Upgrades

For a small yearly donation, you can support this forum and receive a 'Supporting Member' banner, or become a 'Supporting Vendor' and promote your products here. Click the banner to find out how.

Recently Featured

Want to see your truck here? Share your photos and details in the forum.

Ranger Adventure Video

TRS Merchandise

Follow TRS On Instagram

TRS Sponsors


Sponsored Ad


Sponsored Ad


Amazon Deals

Sponsored Ad

Back
Top