Little Truck
New Member
What size bolt do I need to use in a 93 Ford Ranger: Bolts are for the bell housing. I replaced the tranny in 2009 with a 95 Ford Ranger Tranny. I don't know where all the bolts went but I need replacements. Thx all!
-
Welcome Visitor! Please take a few seconds and Register
for our forum. Even if you don't want to post, you can still 'Like' and react to posts.
Bell Housing bolt szie
- Thread starter Little Truck
- Start date
- Joined
- Feb 28, 2001
- Messages
- 9,512
- City
- Dayton Oregon
- Vehicle Year
- 1990, 1997
- Engine
- 2.3 (4 Cylinder)
- Transmission
- Manual
- Total Lift
- 6
- Tire Size
- 35"
If they're like the bolts for a 2.3L they'll be 10mm, and I think most of mine are 55mm long but I didn't measure all of them...
Andy D
Well-Known Member
- Joined
- Jul 9, 2011
- Messages
- 1,940
- City
- Marshfield MA
- Vehicle Year
- 94
- Transmission
- Manual
- My credo
- to prevent Found On the Road Dead, Fix Or Repair Daily
That pretty much is what I found when I did the clutch on the Rat . Bring one of the few you have to a good hardware store.
- Joined
- Jun 1, 2001
- Messages
- 7,897
- Age
- 63
- Vehicle Year
- 1987... sorta
- Transmission
- Manual
2.3 and "cologne" (2.8, 2.9, 4.0 &4.0SOHC) engines are 10mmx1.5
3.0 engines are 12mmx1.75
lengths vary, frankly the OP didn't give us much to go on...
3.0 engines are 12mmx1.75
lengths vary, frankly the OP didn't give us much to go on...
Similar threads
Sponsored Ad
Sponsored Ad
TRS Events
Member & Vendor Upgrades
For a small yearly donation, you can support this forum and receive a 'Supporting Member' banner, or become a 'Supporting Vendor' and promote your products here. Click the banner to find out how.
Recently Featured
Ranger Adventure Video
TRS Merchandise
Follow TRS On Instagram
